Remove Shift Boot Jeep Jk. Take flat blade screwdriver (large one works best) and gently but firmly pry the remaining ring. Remove both the shift knobs for the shifter and the transfer case. i've searched and only found information regarding the removal of the older style shifter boots. Remove the shifter boot bezel from the center console. i have a 2011 jk unlimited with a 6 speed manual trans. Stand with one foot and place it on the flat area of the boot jack. How do you get the boot loose for access to shifter attach bolts? what i found to be the most effective is: (2) remove the manual shifter boot. i just looked in my factory service manual. place upper half of bezel over top of shift boot and line up bolts with holes in shift boot. Pull the shift knob from the shifter rod. 1) remove the shifter knob and transfer case shifter knob with a rubber strap wrench. Under it is a 10mm bolt that needs to be removed along with the one raised by the shift. The front just has a.
from www.quadratec.com
take a small screwdriver and pop out the plastic on top of your shift knob (where the numbers are), there as a nut. (2) remove the manual shifter boot. remove factory shifter bezel and boot assembly by prying up on the rear of the plastic bezel and pulling up to release the. If i try to slip the. The clips are toward the rear of the jeep, see picture. How do you get the boot loose for access to shifter attach bolts? here is my install of my diy shift boot when installing an 8 speed shifter into a. Remove the shifter boot bezel from the center console. the shift lever should slide off. Stand with one foot and place it on the flat area of the boot jack.
DV8 Offroad Shifter Plate for 1215 Jeep Wrangler JK with Automatic
Remove Shift Boot Jeep Jk what i found to be the most effective is: take a small screwdriver and pop out the plastic on top of your shift knob (where the numbers are), there as a nut. Remove both the shift knobs for the shifter and the transfer case. the shift lever should slide off. nested under the transmission levers outer shift boot, this inner rubber core helps to seal from the outside and provide a little. 1) remove the rubber lower cup with a small screw driver. here is my install of my diy shift boot when installing an 8 speed shifter into a. All it says is remove the transmission shift tower dust boot (a). If i try to slip the. i have a 2011 jk unlimited with a 6 speed manual trans. i just looked in my factory service manual. remove factory shifter bezel and boot assembly by prying up on the rear of the plastic bezel and pulling up to release the. what i found to be the most effective is: How do you get the boot loose for access to shifter attach bolts? The clips are toward the rear of the jeep, see picture. First put the shifter in neutral and the transfer.
